Safe Jack 6 Ton Pinch Weld Frame Pad

6 Ton Pinch Weld Frame Pad

• Fits hydraulic jacks with 1.220″ – 1.260″ ram and saddle diameter (31 – 32mm)
• Requires 1/2″ engagement on ram
• Load rating 6 tons
• Use on designated pinch weld jack points.
• Steel construction
• Durable powder coat finish
• Compatible with most 6 ton bottle jacks
• Compatible with Safe Jack extensions
• Made in the USA

Jack in the place designated by your vehicle manufacturer. Safe Jack pads for PINCH WELD POINTS protect your vehicle from damage and increase safety significantly compared to using the jack ram against a non-reinforced structure.  The pad supports the load over a much wider area. The larger contact area adds stability and decreases the load forces on the lift point. The size and shape of the pad makes the jack far less likely to slip or tip when jacking. Jack pads simply slip on the end of a 1.25 inch diameter jack ram or ram screw equipped with the 14125 Extension Screw Collar.  The pad may be connected to ram extensions raising the lift point without the need for cribbing blocks.

Not suitable for use with Toyota Mechanical Jacks, Telescopic Bottle Jacks or Scissor Jacks.

Please note: Some jack manufacturers state their ram diameter, however this can just be the “engagement” area of the saddle at the top where it meets a lift point and not the full diameter. Please measure before purchasing or consider the Pro Lift 6 Ton Jack offered by Pro Quip which has a perfect fit.