The Ignitor® III is a high performance ignition system with special application and operational requirements. It is imperative that applications equipped with resistance wires or ballast resistors be modified according to the installation manual. In all applications in order to achieve the advertised performance gains and system reliability, the integrity of the electrical system should be checked. Here in Australia, Pro Quip hold stock of most popular eight cylinder units, and are able to obtain any available unit required within approximately two weeks.
• For use on 8 cylinder engines
• Not for use with CD or multiple spark systems
• 12 volt negative ground systems
• Lobe sensor design triggers off the point cam or reluctor and does not require a magnet sleeve
• Requires 12-14 Volts
• Must use suppression core ignition wires
• Not intended for marine use.
FOR DELCO DISTRIBUTORS This kit takes just a few minutes to install and is hidden entirely under the distributor cap. Developed for 1957-74 Delco point type distributors with mechanical advance weights on top.
FOR MOTORCRAFT DISTRIBUTORS Our kit retrofits Motorcraft single point vacuum advance distributors. We have completely redesigned the advance plate assembly utilising a custom
nylon glide hub which provides smooth trouble-free operation.
FOR CHRYSLER DISTRIBUTORS This kit fits Chrysler aluminum bodied single point distributors with vacuum advance. The kit features a completely redesigned advance plate assembly utilising a custom nylon glide hub which provides smooth trouble free operation.
FOR DUAL POINT MOTORCRAFT DISTRIBUTORS Dual point and dual point vacuum advance Motorcraft distributors which were used in high performance Ford, Mercury and Pantera applications will certainly benefit from this Ignitor III conversion. This kit simply installs in place of the points and offers performance levels well beyond the reach of points systems.
FOR HOLLEY GOLD BOX DISTRIBUTORS Holley gold box distributors have never before been known for their performance or reliability ...until now. We’ve developed this Ignitor III system to replace the factory electronics. The kit fits entirely within the distributor and triggers off the reluctor.
FOR MALLORY POINT TYPE DISTRIBUTORS Tired of replacing points in your Mallory single or dual point non-vacuum distributor? Want more power? Our new kit will install
in just minutes and has all the features you would expect from a high performance ignition but fits entirely in the distributor.
If you wish to purchase an Ignitor® III and would like to know if there is a unit available to suit your vehicle, simply FAX (03) 9761 1565 , PHONE (03) 9761 1110 or E-mail the following details to us (copy and paste into your email, then add particulars), and we will contact you to advise you if we have an Ignitor® for your vehicle.
Your Details
• Name:
• Business Name (only required for Trade Customers):
• Contact Phone:
• Email Address:
Your Vehicle Details
Note: The more details you can provide, the quicker and more accurate our response will be.
• Year of Manufacture:
• Make (e.g. Holden, Ford):
• Model & Engine (e.g. Torana LX 5.0L, Falcon XA 302):
• No. of cylinders:
• Distributor Make (e.g. Lucas, Marelli, Bosch):
• Distributor Model (e.g.25D4, S145, 231100041):
• Points/Contact Sets Number (preferably Bosch or Echlin aftermarket part numbers)
(e.g. GL19, GM756, GB700):
